24V power through PicoBorg Relays

Submitted by Advm2 on Thu, 07/09/2015 - 20:00

Forums:

I am looking to use the PicoBorg to activate 4 separate 24V relays. The relays will draw minimal current (less than 1A). Will this board handle this voltage?

piborg's picture

piborg

Fri, 07/10/2015 - 09:01

Unfortunately no, PicoBorg can handle a maximum of 20V, we recommend not exceeding 12V.

PicoBorg Reverse would be better suited to 24V relays, however it only has two outputs.
You could either:

  1. Connect two relays to each output, this is fine as long as they do not need individual control
  2. Get two PicoBorg Reverses and connect both of them in a daisy-chain
Subscribe to Comments for "24V power through PicoBorg Relays"