If possible, can you please share a 3D model of the Monsterborg's chassis. I would like to cut a similar chassis but with more width for more powerful motors.
We don't have a 3D model that I can share, but I do have the following information.
These are the overall dimensions for the MonsterBorg and the chassis. The width between the tyres is approximately the same as the distance between the bends for the motor mounting points.
The motor mounting holes will depend on the motors you use, but if you are using our 42mm motors then these motor brackets have the correct hole spacing: Advanced Motor Bracket Mount (Large).
There is also a technical drawing for the mounting bracket if that is more useful here.
The 37 and 42 motors are fitted like this:
piborg
Mon, 12/12/2022 - 10:36
Permalink
MonsterBorg dimensions
We don't have a 3D model that I can share, but I do have the following information.
These are the overall dimensions for the MonsterBorg and the chassis. The width between the tyres is approximately the same as the distance between the bends for the motor mounting points.
The motor mounting holes will depend on the motors you use, but if you are using our 42mm motors then these motor brackets have the correct hole spacing: Advanced Motor Bracket Mount (Large).
There is also a technical drawing for the mounting bracket if that is more useful here.
The 37 and 42 motors are fitted like this:
I hope this helps :)
danesh
Wed, 01/25/2023 - 14:28
Permalink
Sorry, I did not see this
Sorry, I did not see this message earlier. Thank you for your ever prompt response.
Best,
Danesh.